- Detection of wires and cables (live or not):
– detecting of cables in ceilings, walls and floors,
– detecting of breaks in cables,
– tracing of the entire building installation,
– locating power points and switches in buildings,
– locating short circuits between leads,
– tracing shielded cables,
– tracing cables in metal ducts. - Identification of fuses on the distribution board.
- Tracing underground cables.
- Tracing conductive water and heating pipelines.
- Non-contact detection of live cables.
- Features:
– signaling of transmitter and receiver opeartion by LED and sound,
– operation in wide range of rated voltage, up to 500 V RMS,
– three modes of transmitter amplification,
– automatic or manual selection of transmitter operation modes,
– adjustment of receiver sensitivity level (ZOOM function),
– four modes of wire tracer operation – voltage, current, current-voltage and “power”,
– transmitter’s battery charging – high efficiency and low costs.
Electric security:
– type of insulation: double, according to EN 61010 – 1
– measurement category: CAT III 600 V acc. to EN 61010 – 1
– transmitter’s protection class acc. to EN 60529: IP40
– receiver’s protection class acc. to EN 60529: IP40
Other technical data:
– transmitter’s power supply: battery pack SONEL/Ni-MH 9,6 V 2 Ah
– transmitter’s max working voltage: 500 Vrms (707 Vampl)
– transmitter’s dimensions: 230 x 67 x 36 mm
– transmitter’s weight: approx. 490 g
– battery charging temperature: 0…+40°C
– detector’s max range („M” mode): 2 m
– non-contact neon max range: 20 cm (in air), 3 cm (in concrete)
– receiver’s power supply: battery 9 V 6LR61 alkaline
– receiver’s dimensions: 210 x 82 x 24 mm
– receiver’s weight: approx. 200 g
Rated operational conditions:
– operating temperature -20…+50°C
Reviews
There are no reviews yet.